AC Performance Required Tools: • 5mm Allen Key • 10mm Allen Key • 17mm Open-ended Wrench • 8mm Allen Socket • Torque Wrench Install the front stabilizer using a 5mm allen key and a 17mm open-ended wrench to secure two (2) pieces each of the M10 x 50mm screws and M10 nuts.
Page 3
Insert one (1) piece of the trapezoidal fore/aft locking nut into the handlebar post slider then slide the fore/aft handlebar slider onto the han- dlebar post. Insert one (1) piece of the threaded collar locking nut through the hole in the fore/aft handlebar slider and into the trapezoidal fore/aft locking nut then tighten with a 10mm allen key.
Page 4
IF 4IIII POWER SENSOR IS BEING INSTALLED, SKIP THIS STEP AND REFER TO INSTALL DOCU- MENTATION FOR THE 4IIII CRANK ARM. Install the left crank arm onto the left side of the bot- tom bracket ensuring that the right crank arm is at the 12 o’clock position while the left crank arm is at the 6 o’clock position.
Page 5
AC Sport Required Tools: • 5mm Allen Key • 13mm Open-ended Wrench • 12mm Open-ended Wrench • 8mm Allen Socket • Torque Wrench Install the front stabilizer using a 5mm allen key and a 13mm open-ended wrench to secure two (2) pieces each of the M8 x 45mm screws and M8 nuts.
Page 6
First, tighten the fore/aft adjustment pop pin into the handle bar post using a 21mm open-end- ed wrench then loosen the pop pin by turning counter-clockwise. Pull outwards on the pin while sliding the handlebars into the post then thread the M5 x 16mm screw into the underside of the handlebars, tightening with a 4mm allen key to secure.