Table of Contents
Advertisement
CHANNEL and GROUP CHANNEL button LEDs are not lit. Conversely, when Channel mode
is in use these two LEDs are lit.
When switching from Channel to Bank mode, all channel mappings are reset and no
groups are selected for embedding. When switching from Bank to Channel mode, the
channel mappings are retained to allow for further modification.
Embedding
The audio inputs can be embedded into any of the four available groups in the two SDI
outputs. They can be embedded on a per bank basis in the Bank control mode, or a per
channel basis in the Channel control mode. If you embed to a group which is already
present in the SDI video input, then this group is automatically deleted from the video
input prior to the embedding block.
Bank Mode
To embed a bank of audio to a specific group.
1
Select the Embed function using the FUNCTION button.
2
Select the SDI output using the STATUS button.
3
Select the bank of audio using the BANK button.
4
Select the group to embed to, using the GROUP button.
The GROUP button LED will indicate whether embedding is enabled to this group. To
enable embedding to this group, press and hold the GROUP button for two seconds, until
the button turns green. The group number LED will blink to indicate that the change
has been applied. This indicates that embedding is enabled to this group. To disable
embedding to this group, then hold the GROUP button down until the button turns red.
In this mode, the channels of the bank are mapped directly to the group channels. For
example channel 1 in the selected bank is embedded to channel 1 of the selected group.
Channel 2 in the selected bank is embedded to channel 2 of the selected group etc.
Cycling through the groups using the GROUP button, allows the user to determine which
groups are currently enabled for embedding and will also show the source for that group.
Channel Mode
To embed a channel of audio to a specific channel within a group.
1
Select the Embed function using the FUNCTION button.
2
Select the SDI Output, using the STATUS button.
3
Select the bank of audio using the BANK button.
4
Select the bank channel using the the BANK CHANNEL button.
5
Select the group to embed to using the GROUP button.
6
Select the group channel to embed to using the GROUP CHANNEL button.
Redbox Embedder/De-embedder User Handbook
R B - V H C M D 1 6
5
51
Hide quick links:
Advertisement
Table of Contents
