5
INTRODUCTION
Lock Indicator
The lock indicator is lit when the the SDI receiver has detected and locked to the incoming
video format. If the input is disconnected or is intermittent then the lock indicator will stay
unlit.
Output Indicators
These two indicators are used to indicate which one of the two outputs are selected when
configuring the embedding routing or when configuring audio packets for deletion.
Rear Panel Connections
SDI
SDI Outputs
AES D-Type
AES BNC
I/O
I/O
IN
1 and 2
RS232
Power
Ethernet Fuse
Fig 5-3: RB-VHCMD16 Rear Panel
Mains Power
Power is applied via a standard three-pin IEC male socket. Mains voltages between 85V
and264V AC and frequencies between 47 and 63Hz are accepted without adjustment. A
2A, 5 x 20mm SB fuse is used. The Earth pin MUST be connected to ensure safety.
Remote Control
The unit can be controlled remotely either by serial RS-232 or Ethernet using the Sonifex
SCi software. Using remote control allows the user to monitor the status of the unit and
also set various options and settings not available via the front panel.
46
Redbox Embedder/De-embedder User Handbook