Front Panel Indicators & Controls; Fig 3-2: Rb-Vhema8 Front Panel - Sonifex Redbox RB-VHDMA8 User Handbook Manual

3
R B - V H E M A 8
Front Panel Indicators & Controls
Power BANK BANK GROUP GROUP STATUS
LED Button Channel Button Channel Button

Fig 3-2: RB-VHEMA8 Front Panel

Power LED
The POWER LED illuminates whilst internal power is present within the unit. If this indicator
is not on, the most likely reason is simply the absence of mains power, but under fault
conditions it may also indicate a ruptured mains fuse or a problem with the internal power
supply module.
Reset Button
In the unlikely event that the unit fails to respond, press the reset button to reboot the unit.
Bank
The BANK button and its indicators are used to select the audio input bank when
controlling the embedding channel routing.
Bank Channel
The BANK CHANNEL button and its indicators are only used when the unit is operating in
Channel mode and are used to select the audio input bank channel when controlling the
embedding channel routing.
Group
The GROUP button and its indicators are used to select the group number with which to
embed the analogue input channels to. The button LED is used show whether embedding
is enabled to the currently selected group. To enable or disable the embedding to a group,
press and hold the GROUP button for two seconds until the group number indicator blinks.
When lit green it is enabled and when it is lit red it is disabled. When the group is disabled,
no embedding is done to that group number.
Group Channel
The GROUP CHANNEL and its indicators are used to select the channel within the currently
selected group with which to embed the analogue input channel to. This button is only
used when operating in Channel mode. The button LED is used show whether the channel
is enabled for embedding. To enable or disable the channel, press and hold the GROUP
CHANNEL button for two seconds until the channel number indicator blinks. When lit
green it is enabled and when it is lit red it is disabled. When the channel is disabled, no
audio is embedded to that channel. The channel will also not be embedded if the group is
not enabled for embedding, even if the channel is enabled.
Status
This button is used to select the output number when controlling the embedding routing.
It is also used to enter and exit the group deletion mode.
16
Redbox Embedder/De-embedder User Handbook