Socket Cordless Ring Scanner Series 9 User Manual page 55

- If the device previously connected to a Bluetooth CRS, Connect!Agent will
search for the default device.
4. Tap to select your Bluetooth CRS and tap ok. The scanner will appear as
Socket CRS [xxxxxx], where the characters in brackets are the last 6 characters
of the Bluetooth Device Address.
Note: To help you identify the
Bluetooth Device Address, which is labeled on the bottom of the wrist unit.
5. Connect!Agent will connect to the selected Bluetooth CRS.
6. After connecting, the Bluetooth CRS will beep once, and the SocketScan
icon will change into a ring icon.
Note: To connect the computer to the scanner in the future, tap Connect
CS in the SocketScan menu. Connect!Agent will automatically try to
connect to the scanner you last connected to.
Note: To change which Bluetooth CRS is assigned as default, use the
Connect!Agent utility (instructions provided at the end of this chapter).
CHAPTER 5: SETUP FOR NON-SOMO PDAS
Bluetooth
CRS, Connect!Agent reports the
55