Socket Cordless Ring Scanner Series 9 User Manual page 28

Reconnecting
The scanner will disconnect if it is powered off or moves out of the
connection range. If the scanner is powered back on or returns back in range
within 3 minutes after disconnection, SocketScan will automatically attempt
re-connection according to the "auto re-connect" settings you chose in
SocketScan.
• Failure to reconnect will cause the scanner to end auto-reconnect mode
and disconnect. You will then be required to make a connection manually
through SocketScan by clicking on the Socket CS Connect icon on the
desktop.
• A manual connection will also be required if the scanner is not powered
back on or does not return back in connection range within 3 minutes
after a disconnection.
• A connection remains when the smartphone device is in suspend mode.
Note: By default, CS Auto Power off mode is enabled. This mode must be disabled
for automatic reconnections.
Disconnecting
To manually disconnect, click on the SocketScan icon and click Disconnect
CS. The Bluetooth CRS will beep 2 times to indicate the disconnection.
Note: If using ActivePairing, disconnect by turning off the Bluetooth CRS.
Turning off the Bluetooth CRS
To turn off the Bluetooth CRS, press and hold the power button on the wrist
unit for at least 2 seconds, until you hear 2 beeps (high – low).
28