Assembling And Putting On The Bluetooth Crs - Socket Cordless Ring Scanner Series 9 User Manual

A
SSEMBLING AND
STEP 1: Insert plastic clip into slot and gently push down. Repeat on other side.
Attach finger
strap to ring
unit.
Important! Do not twist the clips during insertion or removal!
Note: To remove, grasp a clip and gently pull out. Repeated removal may
distort the post and make it unusable.
STEP 2: Attach Press the wrist unit into the plastic holder of the wrist strap. Align the
the wrist unit.
wrist unit so that the power button on the left side rests in the notch
on the side of the plastic holder.
STEP 3: Put on
When putting on the wrist strap, insert the end of the strap through
wrist strap.
either buckle (or both), depending on the thickness of your arm.
STEP 4: Plug the narrow end of the cable into the connector on the ring unit.
Connect cable
to ring unit.
10
P B
UTTING ON THE
CRS
LUETOOTH