Socket Cordless Ring Scanner Series 9 User Manual page 50

STEP 1: D
ISABLE
Note: This step is required only for ActivePairing (Scenario 2 or 3) with a PDA
with the Broadcom or Widcomm Bluetooth stack.
IDENTIFYING YOUR BLUETOOTH STACK:
Check the About screen of your Bluetooth software to determine if it was
developed by Broadcom or WIDCOMM. The table below lists some devices
that have the Broadcom or WIDCOMM Bluetooth stack:
Device
Dell Axim
Fujitsu LOOX
HP iPAQ
DISABLING THE SERIAL PORT PROFILE:
Open your Bluetooth software. Tap on the Services tab. Next to the Serial
Port option, uncheck the Enable Service option.
STEP 2: U
NINSTALL
Remove any barcode scanning software already installed in your device,
including previous versions of SocketScan.
OPTION 1: Uninstall Directly from the Pocket PC
1. Make sure the barcode scanning software is not running, and no Socket
data collection products are connected to the PDA.
2. Tap Start | Settings. Tap on the System tab or Control Panel.
3. Tap Remove Programs. Use the utility to remove the software.
OPTION 2: Uninstall via ActiveSync
1. Make sure the barcode scanning software is not running, no Socket data
collection products are connected to the PDA.
2. Use ActiveSync and a serial/USB cable or cradle to make an active
connection between your device and a host PC.
3. On the host PC, open Microsoft ActiveSync.
4. Click Tools | Add/Remove Programs. Use the utility to remove the
software.
50
B S
LUETOOTH ERIAL
Operating System
Windows Mobile 2003, 2003SE
Windows Mobile 2003, 2003SE
Windows Mobile 2003, 2003SE, 5.0,
6
O S
THER CANNING
P P
ORT ROFILE
S
OFTWARE