Table of Contents
Advertisement
3 MIDI control
The SINE WARP 9 sends and receives the following MIDI data:
n
Program Changes (1-32, reception only on the active receive channel)
n
Midi Clock (for LFO reset)
n
Note On/Off (for ENV/VCA triggers, reception only on the active receive channel)
n
Control Changes (sending and reception only on the active receive channel)
If a parameter is modified by changing one of the controls, the SINE WARP 9 will send an
appropriate control-change message to the MIDI OUT which can then be recorded by a
MIDI sequencer. If these controller messages are sent back to the SINE WARP 9, the
parameter will be set according to the value. The following table provides an overview of
the parameters and the associated controller messages sent and received via MIDI.
Parameter
ENV mode
Cutoff
Resonance
Attack
Decay
Sustain
Release
Delay
LFO rate
LFO depth
Controller value 0 corresponds to the control knob in the minimum position.
Controller value 127 corresponds to the control knob in the maximum position.
n Controller Changes (reception only on the active receive channel)
Parameter
VCA control
LFO reset:
Filter mode
Modulation wheel
30
Controller number
103
104
105
106
107
108
109
110
111
112
Controller number
113
104
105
106
Controller values
0 – 127
0 – 127
0 – 127
0 – 127
0 – 127
0 – 127
0 – 127
0 – 127
0 – 127
0 – 127
Controller values
0 – 127
0 – 127
0 – 127
0 – 127
SINE WARP 9 (English)
Advertisement
Table of Contents
