Introduction; Connectors And Controls - TerraTec SINE WARP 9 Manual

1 Introduction

1.1 Connectors and controls:

The front panel:
1. POWER:
2. Program:
3. Write:
4. Channel:
5. Mode:
6. Select:
7. A/B:
8. LP:
9. HP:
10. BP:
11. N:
12. TRIGGER:
13. - 1 TRIGGER SOURCE: Selection of source (MIDI/analog) for ENV and VCA triggers
- 2 ATTACK:
-3 LFO RATE:
14. - 1 VCA MODE:
- 2 DECAY:
- 3 LFO DEPTH:
15. - 1 ENV TRIGGER:
- 2 SUSTAIN:
- 3 KEY FOLLOW:
16. - 1 LFO WAVE:
- 2 RELEASE:
- 3 VELOCITY:
6
Power switch
Program selection within the program group
Save/copy program
Global MIDI send and receive channel
Filter type selection (monitor LED: LP/HP/BP/N)
Selection of the active Modulation 1 parameter
Selection of the program group 1-16/17-32
Low-pass filter LED
High-pass filter LED
Band-pass filter LED
Notch filter LED
Monitor LED for a trigger signal
Envelope attack time
LFO speed
Selection of VCA modulation
Envelope decay time
Intensity of the filter modulation (cutoff) by the LFO
Envelope trigger mode
Sustain level of envelope
Intensity of the filter modulation (cutoff) by MIDI notes
Selection of the LFO waveform
Release time of the envelope
Intensity of the filter modulation (cutoff) by MIDI velocity
SINE WARP 9 (English)