Copying And Saving Programs; Midi Send And Receive Channels - TerraTec SINE WARP 9 Manual

2.9 Copying and saving programs

Individual parameters of a program that have been changed will be lost when choosing a
new program or switching the device off. Parameter changes to a program must be saved
if you intend to keep them.
n
Saving a program
o Press the Write button briefly until the Write LED is lit.
o Press the Write button again. All parameter changes to the currently se-
lected program will be saved. After the program has been saved, the pro-
gram selection function will be activated automatically.
n
Copying a program
o Press the Program button briefly to select the program to copy.
o Press the Write button briefly until the Write LED is flashing.
o Press the Program button briefly (the Write LED will continue to flash) to
select the target program within the current program group, or hold the
Program button to select a target program group (A/B). The target program
will be displayed as described in 2.8.
o Press the Write button to copy the program. After the program has been
copied, the program selection function will be activated automatically.
Note: Press the Channel or Mode button to cancel the copy operation.

2.10 MIDI send and receive channels

The SINE WARP 9 sends and receives the following channel-dependent MIDI data:
n
Program Change messages for program selection (receive)
n Note On/Note Off for envelope triggering (receive)
n
Control Change messages for parameter changes (send and receive)
A shared send and receive channel can be selected at the SINE WARP 9 for sending and
receiving data.
SINE WARP 9 (English) 27