Table of Contents
Advertisement
n DLM (Delay-LFO Modulation)
In this mode, each trigger signal after Trigg Source triggers the envelope, but the
decay time changes depending on the current LFO value. The effect on the decay
times depends on the position of the Decay control. Positions near the minimum and
maximum values are especially effective.
Example: Range 1, triangle LFO, Delay, Attack, Sustain and Release minimum
SINE WARP 9 (English)
Range 1:
Increasing (decreasing) LFO values cause the decay to
increase (decrease). The closer the control is to the MIN
position, the shorter the overall decay time.
Range 2:
Depending on the current LFO value, the device switches
between maximum (high LFO value) and minimum decay time
(low LFO value). The closer the control is to the MAX position,
the more prevalent minimal decay times will be.
15
Advertisement
Table of Contents
