Table of Contents
Advertisement
4 Modulation 1
This section is organized in the 3 parameter groups Select 1, Select 2 and Select 3. Use
the Select button to select one of the 3 parameter groups. You can then edit the individual
parameters within the group with the above control knobs.
When switching to a different parameter group while editing parameters, the positions of
the control knobs will still show the values of the previous group, even if the parameters of
the current group have completely different values. The parameter will not take on the
value shown by the control knob until you move the knob. An example: suppose you have
chosen Select 2 and set the Attack value to minimum. Next, you choose Select 3 and set
the LFO Rate to maximum. If you go back to Select 2, the control knob will be set to
maximum, but the Attack value will still be at minimum. If you now move the control knob,
the Attack value will change to the current position of the control knob.
The control knobs of the 3 parameter groups have different value ranges. The values on
the labels of the front panel of the Warp 9 apply to the Select 1 parameters.
SINE WARP 9 (English)
31
Advertisement
Table of Contents
