Env Trigger Mode - TerraTec SINE WARP 9 Manual

Midi analog multimode filter

Table of Contents

2.3.2 ENV TRIGGER MODE

Each trigger signal after the trigger source triggers the envelope.

N2,N3,N4,N5

The envelope is triggered only after every other (N2), every third (N3), every fourth

(N4) or fifth (N5) trigger signal. All trigger signals in between are ignored.

Example: Trigger Source: Single, ENV MODE: N3

n RPT

During an active trigger signal, the envelope will be triggered again every time the

envelope voltage drops to the sustain level (end of the decay phase). This occurs with

increasing frequency the lower the delay, attack and decay times are. The release

phase does not begin until the end of the trigger. Very short delay, attack and decay

times result in a very high repeat frequency, resulting in an effect similar to a ring

modulator.

Example: Delay, Attack at minimum, Sustain 50%

SINE WARP 9 (English)

Table of Contents