Rgb Setup Button Types - AMX G3 Firmware Instruction Manual

Editor and Setup Reference
!
The RGB Setup page acts the same as the Video Setup page, and adapts to the
specific (RGB) input module.

RGB Setup button types

This feature sets the button to open the RGB Setup page (FIG. 31) so you can adjust the incoming
RGB signal on the touch panel. Select
button to RGB Setup. The button type RGB SETUP and associated options appear in the Button
Properties page. The TPI/3 RGB Setup page appears after you select the Slot # that corresponds to
the RGB card. If the RGB card is found in Slot 2, then you must go through the Video Setup page
(XXX) and press
FIG. 31 RGB Setup page for both a sample VGA compatible panel and the AXB-TPI/3
This page only appears when the panel is video capable. The RGB Setup page acts the same as the
Video Setup page, and adapts to the specific (RGB) input module.
!
52
• JOYSTICK CENTER sets the button to a 4-quadrant joystick with a control stick located in the
center. When you move the control stick, the touch panel sends data to the Controller and to
the external device to perform a pre-programmed operation. When you release the mouse
button (or other touch device), the control stick returns to the center of the icon and the
external device returns to its default position.
• CROSSHAIR NON-CENTER sets the button to a 4-quadrant crosshair with a control stick
located off-center. When you move the control stick, the touch panel sends data to the
Controller and to the external device to perform a pre-programmed operation. When you
release the mouse button (or other touch device), the control stick and external device stay in
that position.
• CROSSHAIR CENTER sets the button to a 4-quadrant crosshair with a control stick located in
the center. When you move the control stick, the touch panel sends data to the Controller and
to the external device to perform a pre-programmed operation. When you release the mouse
button (or other touch device), the control stick returns to the center of the icon and the
external device returns to its default position.
BUTTON OPTIONS (AXB-TPI/3) opens the
to assign the video input slot to view this button. Press ABORT to close the menu.
• SLOT 1 sets the button to view the video from input slot 1.
• SLOT 2 sets the button to view the video from input slot 2.
• SLOT 3 sets the button to view the video from input slot 3.
to get the RGB Setup page.
SLOT 1
SLOT X shows the video input slot number that you are currently modifying/viewing.
BUTTON OPTIONS
from the Button Type menu to set the selected
RGB SETUP
menu. Use this menu
G3 Firmware Design and Reference