Table of Contents
Advertisement
Illumination is dependent only on the LS and corresponding light threshold. It does
not matter whether the panel is in Wake/Sleep mode or whether the Light Sensor is
set to DRM or NRM.
!
!
External CP4 PushButtons
The functionality of these external pushbuttons is like those of other touch panels. The assignments
for these pushbuttons include Device/Channel numbers, Flip to Page options, and a string/macro
option. The properties for these buttons is set from the
in touch panel Edit mode. Refer to the G3 Firmware Design and Reference instruction manual for
more information on working with the firmware.
Setting the External PushButton Illumination
The functionality of these illuminated external pushbuttons is like those of other touch panels. The
assignments for these pushbuttons include Device/Channel numbers, Flip to Page options, and a
string/macro option. The properties for these buttons are set from the
PROPERTIES
The external pushbuttons are backlit according to the illumination options on the Sensor Setup
page. You can choose from five different illumination modes from a combination of the three lower
buttons on the Adjust Sensors page:
page 16 and page 17 for more information on these modes.
To activate the Button Illumination modes:
1. Press
2. Select a combination of the three illumination buttons that achieves the desired illumination.
The various illumination modes can also be set through the use of Send_Commands applicable to
the different touch panel types.
G3 Firmware Design and Reference
BUTTON ILLUMINATION
(Off). You can also adjust this mode via the PBIL Send_Command.
mode is a combination of the first two automatic mode buttons (
PIR/LS AUTO
button illumination). You can also adjust this mode via the PBIL Send_Command.
The order of precedence for illumination of the pushbuttons is PIR then
!
pushbuttons illuminate if there is PIR activity, without regard to the level of the light
sensor. The pushbuttons also illuminate if there is no PIR activity and the light
sensor level falls below its threshold value.
The order of precedence for turning off the pushbuttons is the
!
light sensor rises above its hysteresis (turn-on) value and there is no any activity
coming from the PIR (thirty seconds of inactivity), the buttons turn off.
menu while Edit mode.
from the Setup page.
ADJUST SENSORS
mode sets the pushbuttons to either illuminate (On) or not
>
EDIT
BUTTON
,
,
,
ON
OFF
PIR AUTO
LS AUTO
Designing Touch Panel Pages
and
PIR
. The
LS
then PIR. If the
LS
>
menu while
PROPERTIES
>
>
EDIT
BUTTON
, and
. Refer to
PIR/LS AUTO
LS
17
Advertisement
Table of Contents
