AMX G3 Firmware Instruction Manual page 57

!
!
!
!
!
!
Incoming Video Resolutions and Refresh Rates for 10.4" Panels
Name
DOS
VGA
SVGA
XGA
G3 Firmware Design and Reference
RED/GREEN/BLUE allows you to increase/decrease the respective red/green/blue
values of the incoming video signal by pressing the
range for all is from 0-67 (the AXB-TPI/3 range is 0-255). Press
reset the panel to factory settings.
VERTICAL (V POSITION) allows you to increase/decrease the relative video signal
position of the button on the output device by pressing the
range is from 0-15 (the AXB-TPI/3 range is 0-255). Press
panel to factory settings.
HORIZONTAL (H POSITION) allows you to increase/decrease the relative video
signal position of the button on the output device by pressing the
horizontal range is from 0-31 (the AXB-TPI/3 range is 0-255). Press
reset the panel to factory settings.
H SIZE allows you to increase/decrease the relative video signal position of the button on
the output device. The horizontal size range is from 0-255. Press
reset the panel to factory settings.
TRACKING allows you to increase/decrease the relative video signal tracking on the
output device by pressing the
Tracking is always set to 0 as the default.
RGB PRESENT / RGB NOT PRESENT displays the type of video signal being
supplied and whether the signal is or is not present. RGB consists of the Red, Green, and
Blue colors within the video signal. The panel de-faults to displaying
there is a connection to the VGA connector. Once a signal is received, the touch panel
automatically detects it, locks in on the signal type, and displays the video type in the
button. The other display types shown in the following table denote the resolution of the
incoming computer video signal and the supported refresh rates for that video signal.
Resolution
640 x 400
640 x 480
800 x 600
1024 x 768
or
UP
or buttons. The tracking range is from 0-31.
UP DN
Supported vertical refresh rates
70 Hz
60 Hz
72 Hz
52 Hz
60 Hz
72 Hz
60 Hz
70 Hz
Editor and Setup Reference
buttons. The color value
DN
to
SET TO DEFAULT
or buttons. The vertical
UP DN
to reset the
SET TO DEFAULT
or buttons. The
UP DN
SET TO DEFAULT
to
SET TO DEFAULT
RGB PRESENT
to
if
53