Table of Contents
Advertisement
Designing Touch Panel Pages
FIG. 3 Protected Setup page with the inactive Wireless Settings button (pack attached)
6. Press
7. Press
indicating Edit mode is active.
8. Press
(FIG. 4). These options allow you to design and modify button and page settings on the panel.
FIG. 4 Main page with Edit bar
Setting the Device Base
1. Press the
device address to the touch panel.
2. Enter the base address for the touch panel. The base address range is from 1 - 255. Standard
device addresses begin at 128.
3. Press
Setting the Device Used
Use the
of devices being controlled by the touch panel.
1. Press
device number supports up to 255 programmable channel codes. The multiple device settings
allow you to create up to four unique touch panel buttons and/or pages. This value is used to
determine the current device numbers being used by the panel.
2. Enter the number of devices being used by the touch panel.
8
to close the Protected Setup page and return to the Setup page (now in Edit mode).
EXIT
again to return to the Main page. The
EXIT
to open the Edit bar containing the
EDIT
option, in the Protected Setup page (FIG. 3), to assign a base (starting)
DEVICE BASE
to save.
ENTER
option in the Protected Setup page (FIG. 3) to assign a value for the number
DEVICE USED
to open the keypad and enter the panel's device number from 1 - 4. Each
DEVICE USED
Only appears active if you have a wireless
battery pack attached to the touch panel or
if you are using a two-way
wireless ViewPoint touch panel (VPN series)
button appears at the top of the page
EDIT
and
options, in the Edit bar
BUTTON
PAGE
Edit bar
G3 Firmware Design and Reference
Advertisement
Table of Contents
