Adjusting The Display Brightness; Using The Direct Function - Onkyo A-9000R Instruction Manual

Adjusting the Display Brightness

You can adjust the brightness of the integrated amplifier's
information display.
Display Off LED
DIMMER
En
30
1 Press DIMMER repeatedly.
Normal → Dim → Off
Normal
Dim
Off
The Display Off LED lights.
Note
• While the information display is turned off, pressing the buttons
used for settings and adjustments on the remote controller or
integrated amplifier will briefly activate the display in Dim
mode.

Using the Direct Function

By bypassing the tone control circuit, the Direct function
uses the shortest path for enhanced sound quality.
Although this function generally turns the display off, the
integrated amplifier makes use of a display that doesn't
affect the sound quality. It is therefore possible to turn the
display on while the Direct function is enabled. Also,
since the left/right balance setting uses a system that
doesn't affect the sound quality, the balance can be
adjusted even if the Direct function is enabled.
DIRECT switch DIRECT LED
1
Set the DIRECT switch to the ON position.
The information display goes off and the DIRECT
LED lights.
Tip
• To turn the information display on while the Direct function is
enabled, press DIMMER on the remote controller.