Skipping Unused Inputs
You can hide the display of those inputs that are not used,
so that they are skipped when selecting an input. Change
any input from the following: L1(LINE1), L2(LINE2),
L3(LINE3), CX1(COAX1), CX2(COAX2), OPT,
AES(AES-EBU), USB, PNO(PHONO)
■ Operating with the remote controller
ENTER
RETURN
SETUP
1
Press SETUP.
2
Press
/
repeatedly to select "SHOW".
3
Press ENTER.
4
Press
/
repeatedly to select the input you want
to change.
5
Press
/
to switch between ON and OFF.
ON:
Shows the display of selected input.
OFF:
Hides the display of selected input.
The setting is automatically confirmed.
6
Press RETURN repeatedly to exit the setup.
■ Operating on the integrated amplifier
/
/ /
1
Press SETUP repeatedly to select "SHOW".
2
Use the INPUT selector to select the input you want
to change.
3
Press and hold down SETUP.
The setting is switched ON/OFF.
The setting is automatically confirmed.
4
Press SETUP repeatedly to exit the setup.
Tip
• The default setting is ON.
Note
• The current input doesn't appear as selectable. For example, if
the input is currently set to "LINE1", "L1" won't appear as
selectable.
• The integrated amplifier will end the setup if there is no
operation for 8 seconds.
SETUP
INPUT selector
Setting the Headphone Level
You can set the volume when using headphones.
■ Operating with the remote controller
ENTER
RETURN
SETUP
1
Press SETUP.
2
Press
/
repeatedly to select "HPLVL".
3
Press ENTER.
The current level is displayed.
4
Press
/
repeatedly to adjust the offset level.
You can adjust the offset level from -12 dB to +12 dB
in 1 dB steps.
The setting is automatically confirmed.
5
Press RETURN repeatedly to exit the setup.
/
/ /
En
37