Selecting Speakers A And Speakers B; Adjusting The Volume; Selecting The Input Source - Onkyo A-9000R Instruction Manual

Selecting Speakers A and Speakers B

You can select to output sound from Speakers A,
Speakers B, or both A + B.
SPEAKERS A B
1 Press SPEAKERS repeatedly on the integrated
amplifier.
The LED of the selected speakers lights.
Note
• While headphones are connected, this setting is disabled.
• When "ROUTE" is set to "PRE", this setting is disabled
page 39).
(➔
• When this setting is set to A + B, the impedance of speakers is
restricted. For further details, see "Connecting Your Speakers"
(➔ page 15).

Adjusting the Volume

You can adjust the volume within the following range:
VOLMIN, -95dB, -90dB, -85dB, -80dB to 14dB,
VOLMAX
■ Operating with the remote controller
VOLUME /
1
Press VOLUME / repeatedly.
■ Operating on the integrated amplifier
Volume controller
1 Use the volume controller.
Tip
• The default level is -55 dB.

Selecting the Input Source

You can switch inputs to select the desired source
component. Choose an input from the following:
LINE1, LINE2, LINE3, COAX1, COAX2, OPT,
AES-EBU, USB, PHONO
■ Operating with the remote controller
INPUT /
1
Press INPUT / repeatedly.
■ Operating on the integrated amplifier
INPUT selector
1 Use the INPUT selector.
Tip
• For changing the input's name, see "Changing Input Names"
(➔ page 36).
• To hide the display of unused inputs, see "Skipping Unused
page 37).
Inputs" (➔
Note
• If there is no USB connection, "USB" is not displayed.
En
29