Using The Direct Function; Adjusting The Display Brightness; Changing The Display Information - Onkyo P-3000R Instruction Manual

Using the Direct Function

1 Press DIRECT on the preamplifier to turn the
Direct function on or off.
When the Direct function is off, the tone controls can be
used to adjust the sound. When the Direct function is on,
the tone controls are bypassed, so you can enjoy a pure
sound, then front display goes off and the Direct LED
lights.
Note
• The display lights for 5 seconds if you control anything else than
volume or DIMMER on the front panel or remote controller
when the display brightness is set to OFF.
En
28

Adjusting the Display Brightness

Direct LED
DIRECT
You can adjust the brightness of the preamplifier's display.
1 Press DIMMER repeatedly to change the brightness
of the display in sequence.
Normal → Dim → Off
Note
• The display lights for 5 seconds if you control anything else than
volume on the front panel or remote controller when the display
brightness is set to OFF.
Display Off LED
DIMMER
Normal
Dim
Off
The Display Off LED lights.

Changing the Display information

DISPLAY
You can display the selected selector or the setting value.
1
Press DISPLAY to switch the display in sequence.
Selector
BASS
TREBLE
Input fs (sampling rate)
fs indicator
Output fs (sampling rate)
Note
• Input fs (sampling rate) and output fs (sampling rate) are
displayed only while the DIGITAL selector is selected.
• Depending on the source, sometimes the value of the sampling
rate differs from the actual display.