2-14 Installation
5. The information-card tray located on the bottom of the
RF-Display section requires a space of approximately 2 cm
below the instrument when rack mounting. See callout 1 in
Figure 2-9. (No filler strip is provided.) If you wish to remove
the information-card tray, remove the feet and tilt stands. See
I
Figure 2-9. Removing the Information-Card Tray
6. Place the RF section right side up on a level work surface.
7. Place the IF-Display section on top of the RF section, offset far
enough forward to allow the RF section hooks to engage the
IF-Display section frame when slid back. Slide the IF-Display
section back until the RF section hooks catch the bottom of the
IF-Display section.
8. Line up the rear-panel lock feet, and tighten the thumb screws on
both lock feet.
9. Attach the 10-l/2 inch handles with flanges as shown in
Figure 2-10.