HP ESA-L1500A User's And Calibration Manual page 263

Performance Verification Tests
15. Gain Compression
,
Amplitude Amptd Units, dBm, Done
,
Amplitude 10 dBm, Attenuation Auto Man 0 dB
,
Scale/Div 2 dB
,
BW/Avg 30 kHz
6. On the synthesized sweeper, adjust the power level for a 0 dBm
reading on the measuring receiver. Set RF to Off.
75 Input only: Adjust the power level for a 2.0 dBm reading.
7. On the synthesized signal generator, set the amplitude to 14 dBm.
8. Disconnect the power sensor from the directional bridge and connect
the directional bridge to the Input 50
analyzer using an adapter. Do not use a cable.
75 Input only: Use a 75
9. On the spectrum analyzer, press the following keys:
Peak Search
,
Frequency Signal Track On Off
,
Span 150 kHz
Wait for the Span 150 kHz message to appear.
10.On the synthesized signal generator, adjust the amplitude to place
the signal 16 dB below the spectrum analyzer reference level.
11.On the spectrum analyzer, press
12.On the synthesized sweeper, set RF to On.
13.On the spectrum analyzer, press
14.Read the marker delta amplitude and record its absolute value in
the performance verification test record as TR Entry 1.
15.On the spectrum analyzer, press
262
connector of the spectrum
adapter, BNC (m) to BNC (m).
(On)
, then
Peak Search
.
Search
System, Alignments, Auto Align, On.
, .
Marker Marker
Chapter 9