A2 Driver Assembly Removal/Replacement - Agilent Technologies 11713A Operating And Service Manual

A2 Driver Assembly Removal/Replacement

This module contains components that can be damaged or destroyed by
CAUTION
electrostatic discharge. It should be serviced at a static-safe
workstation. Refer to "Preparing a Static-Safe Work Station" in
Chapter 8
To Remove the A2 Driver Assembly
1. Remove the top cover.
2. With a strong upward motion, lift the red ring at the top edge of the
To Replace the A2 Driver Assembly
1. Gently insert the board into the socket marked A2 with a vertical
2. Replace the top cover.
A2 driver and remove the assembly.
motion. Use balanced pressure from your thumbs to push the board
into the socket.
Replacing Major Assemblies
A2 Driver Assembly Removal/Replacement
11713 Operating and Service Manual 7-9