Module Cover Removal/Replacement - Agilent Technologies 11713A Operating And Service Manual

Module Cover Removal/Replacement

This module contains components that can be damaged or destroyed by
CAUTION
electrostatic discharge. It should be serviced at a static-safe
workstation. Refer to "Preparing a Static-Safe Work Station" in
Chapter 8.
Top and bottom covers are removed and replaced similarly.
NOTE
To Remove Module Covers
1. Unscrew the one single screw in the middle of the cover flange that
2. Slide the cover toward the rear of the module.
To Replace Module Covers
1. Slide the cover toward the front of the module.
2. Tap on the cover to ensure that all sides fit snugly.
3. Tighten the holding screw at the rear flange.
holds the cover to the rear panel.
Replacing Major Assemblies
Module Cover Removal/Replacement
11713 Operating and Service Manual 7-5