Rear Panel Removal/Replacement - Agilent Technologies 11713A Operating And Service Manual

Rear Panel Removal/Replacement

This module contains components that can be damaged or destroyed by
CAUTION
electrostatic discharge. It should be serviced at a static-safe
workstation. Refer to "Preparing a Static-Safe Work Station" in
Chapter 8.
To Remove the Rear Panel
1. Remove the top and bottom covers. Refer to "Module Cover
2. Remove the two screws at the GPIB connector.
3. Remove the four comer screws that secure the rear panel to the
4. Disconnect the ribbon cable from the A1 interconnect/power supply
5. Separate the rear panel from the module.
To Replace the Rear Panel
1. Position the rear panel onto the rear-panel frame.
2. Connect the ribbon cable from the A1 interconnect/power supply
3. Secure the rear panel to the module with the four comer screws.
4. Replace the two screws at the GPIB connector.
5. Replace the top and bottom covers.
Removal/Replacement".
module.
assembly to the rear panel.
assembly to the rear panel.
Replacing Major Assemblies
Rear Panel Removal/Replacement
11713 Operating and Service Manual 7-7