Table 6-1 Gpib Message Reference Table - Agilent Technologies 11713A Operating And Service Manual

Remote Operation
Table 6-1 summarizes the driver's GPIB capabilities in terms of the
twelve bus messages.

Table 6-1 GPIB Message Reference Table

GPIB Applicable
Message
Data yes
Data No
Trigger No
Clear No
Remote Yes
Local No
Local Lockout Yes
Clear Lockout/ Yes
Set Local
Pass No
Control/Take
Control
Require No
Service
Status Byte No
Abort No
a.
Commands, control lines and Interface functions are defined in IEEE Std 488 and ANSI Sid MC1.1.
Knowledge of these might not be necessary if your controller's manual describes programming in terms of
the twelve GPIB messages shown in the left column.
b.
The driver does not have complete RU capability since it can not process the Go-To-Local (GTL) message.
Complete GPIB capability as defined in IEEE Std 488 and ANSI Std
MC1.1 is:
SH0, AH1, T0, TE0, L2, LE0, DC0, DT0, RL1, C0, SR0, PP0.
6-6 11713A Operating and Service Manual
Response
All front panel functions, except LINE
ON/OFF switch, are programmable. The
front panel REMOTE indicator turns on
when addressed.
The driver does not respond to the
trigger message
The driver does not respond to the clear
message.
The driver does not respond to the clear
message
The driver remote mode is enabled when
the REN bus line is true. However, R
remains in local (i.e, the front panel is
active) until it is addressed to listen the
first time. The output signal is
unchanged. The front panel REMOTE
indicator turns on when in remote mode.
The driver does not respond to the Local
message. Refer to Clear Lockout/set
Local.
LOCAL key is disabled. Only the
controller can return to the driver to
local.
Driver goes to local and local lockout is
cleared when REN goes false.
The driver has no controller capability
The driver does not respond to a serial
poll.
The driver does not respond to a parallel
poll.
The driver stops listening
Related Interface
Commands Functions
and
a
Controls
TO, L2, AH1,
SH0
GET DT0
DCL, SDC DC0
REN
b
RL1
GTL b
RL1
LLO b
RL1
b
RL1
REN
b
RL1
SRQ SR0
SPE, SPD T0
PP0
IFC T0,L2