Specifications - Follett 25 Installation, Operation & Service Manual

Specifications

Electrical
1. Models with Satellite-fill icemakers (25CR400A/W, 50CR400A/W, 25HR400A/W, 50HR400A/W)
Basic electrical: 115V/60Hz/1 phase
2. Freestanding models and models with integral icemakers (25FB400A/W, 50FB400A/W,
25CT400A/W, 50CT400A/W, 25HT400A/W, 50HT400A/W)
Basic electrical: 115V/60Hz/1 phase
3. Dispensers and Satellite-fill icemakers are supplied with 7-foot power cord with NEMA 5-20 hospital grade
plug. Connect to 20 amp circuit fuse or breaker.
Note: It is preferred that circuit be protected by a GFCI.
Ambient
Air temp
Water temp
Water pressure
Plumbing
Dispenser drain
Icemaker drain
Dispenser water inlet
Satellite-fill IM water inlet
Cond. inlet – w/c only
Cond. drain – w/c only
Note: Water shut-off recommended within 10 feet (3m) of dispenser. Drain to be hard piped and insulated, and maintain
slope of at least 1/4" per foot (6mm per 30.4cm run) of slope. All plumbing connections must be made in accordance with
local building codes.
Ventilation clearances
Countertop and wall mount models with Satellite-fill icemaker (25CR400A/W, 50CR400A/W, 25HR400A/W,
50HR400A/W) — none. 12" (305mm) at top advised for service.
Countertop and wall mount models with integral icemaker (25CT400A/W, 50CT400A/W, 25HT400A/W,
50HT400A/W) — 6" (153mm) at top. 6" (153mm) each side advised for service.
Freestanding models (25FB400A/W, 50FB400A/W) — 4" (102mm) at rear. 12" (305mm) at top advised
for service.
100° F/38°C max.
90°F/32°C max.
70 P.S.I. max.
25/50 CR with 25/50 HR with
Satellite-fill Satellite-fill
icemaker icemaker
3/4" FPT 3/4" ID tubing
3/4" MPT
3/8" FPT
3/8" OD push-in 3/8" OD push-in
3/8" FPT
3/8" FPT
Icemaker Max. fuse
11.0 amps 20 amps
Total system Max. fuse
14.0 amps 20 amps
50°F/10°C min. (best performance below 80˚F/27˚C)
40°F/4°C min. (best performance below 70˚F/21˚C)
10 P.S.I. min.
25/50 CT with
integral
icemaker
3/4" FPT
3/4 MPT –
3/8" FPT 3/8" FPT
–
3/8" FPT 3/8" FPT
3/8" FPT 3/8" FPT
4
Dispenser Max. fuse
4.0 amps 20 amps
25/50 HT with 25/50 FB
integral icemaker
icemaker in base
3/4" ID tubing 3/4" FPT
– 3/4" MPT
3/8" FPT 3/8" FPT
–
3/8" FPT 3/8" FPT
3/8" FPT 3/8" FPT
–