Setting Of The Power Up Delays; Reading Out Of The Power Up Delay(S); Reading Out Of The Power Up Delays - ADDER ePowerSwitch 8XS User Manual

User Guide

6.3.3. Setting of the power up delays

This command enables to set the Power Up Delay individually for each power outlet. The Delay value can
be between 1 and 255 seconds (4 min 15 sec).
Command to be sent to the ePowerSwitch 8XS:
TUxy=z[CR]
Reply from the ePowerSwitch 8XS:
TUxy=z[CR]
Explanations:
Parameter
x address of the ePowerSwitch
y number of the power outlet
z timer value
Examples:
TU12=2 Set power up delay of the power outlet #2 of ePowerSwitch #1 to 2 sec
T163=10 Set power up delay of the power outlet #3 of ePowerSwitch #16 to 10 sec
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by
the character [CR].

6.3.4. Reading out of the power up delay(s)

This command enables to read out the power up delay individually for each power outlet.
Command to be sent to the ePowerSwitch 8XS:
TUxy[CR]
Reply from the ePowerSwitch 8XS:
TUxy=z[CR]
Explanations:
Parameter
x address of the ePowerSwitch
y number of the Power Outlet
z timer value
The ePowerSwitch 8XS accepts lower case and upper case commands.
The ePowerSwitch 8XS sends its reply only after having received a valid command terminated by
the character [CR].
Value
1 to 16 specifies the number of the ePowerSwitch 8XS
1 to 8 specifies the number of the power outlet
1 to 255 set the power up delay (in sec)
Value
1 to 16 specifies the number of the ePowerSwitch 8XS
1 to 8 specifies the number of the power outlet
1 to 255 shows the power up delay (in sec)
Function/Remark
Function/Remark
Page | 14