ADDER ePowerSwitch 8XS User Manual page 11

ePowerSwitch 8XS
2. Allocate an address to each Satellite by positioning the address selection DIP-switches marked "Slct"
on the front panel according to the following table.
Remarks
− Unplug the power cords of the ePowerSwitch 8XS before changing its DIP switches.
− Do NOT use the same address for two different Satellites.
Satellite DIP-Switch
Address 1
1 Off
2 [ON]
3 Off
4 [ON]
5 Off
6 [ON]
7 Off
8 [ON]
9 Off
10 [ON]
11 Off
12 [ON]
13 Off
14 [ON]
15 Off
16 [ON]
3. On both devices located at the end of the xBus, switch the DIP-Switch 5 and 6 to ON to activate
the built-in termination resistors.
4. Plug the 2 power cables into 2 grounded sockets. The A and B LEDs light on to confirm that power is
on.
Page | 9
DIP-Switch DIP-Switch
2 3
Off Off
Off Off
[ON] Off
[ON] Off
Off [ON]
Off [ON]
[ON] [ON]
[ON] [ON]
Off Off
Off Off
[ON] Off
[ON] Off
Off [ON]
Off [ON]
[ON] [ON]
[ON] [ON]
DIP-Switch
4
Off
Off
Off
Off
Off
Off
Position Off = switch upwards,
Position On = switch downwards
Off
Off
DIP-Switch 1 is located on the left side
[ON]
[ON]
DIP-Switch 5 and 6 are used to activate
[ON]
the built-in termination resistors.
[ON]
[ON]
[ON]
[ON]
[ON]