Making Drinks; Switching On; Pre-Warming Cups - Miele CVA 5065 Operating And Installation Manual

Making drinks

Switching on

When you switch the coffee machine on
it will start heating up and the pipework
will be rinsed through. This cleans and
pre-heats the pipework in preparation
for making coffee.
^ Touch the On/Off sensor s.
The following message will then
appear:
Heating phase
If the automatic Rinsing programme
option has been set to "On" (factory
default setting), the following will
appear after the machine has heated
up:
Rinsing
Water will run out of the central spout.
To prevent water from
running into the drip tray,
always place an empty cup
or the small cleaning container under
the central spout before making the first
drink.
The main menu will then appear in the
display:
Espresso
H I
q r
20
L
J
m
n

Pre-warming cups

The cups should always be
pre-warmed to allow the flavour to
develop and be retained. The aroma of
espresso does not react well to cold.
The smaller the volume of
coffee/espresso and the thicker the
cup, the more important it is to
pre-warm the cup. Use a plate warming
drawer if you have one. If not, you can
warm them as follows:
^ Place the cup to be warmed under
the hot water spout.
^ Touch the Hot water sensor.
^ Run a little hot water into the cup to
warm it.
^ Touch the OK sensor to stop the flow
of water.
^ Leave the cup for about a minute
until it is warm, then pour the water
away.
C