Miele CVA 5065 Operating And Installation Manual page 71

. . . no water comes out of the central
spout.
The filters in the brew unit are dirty.
^ Remove the brew unit and clean the
filters with your finger (see "Cleaning
and care - Brew unit").
. . . the brew unit or the waste
container cannot be pulled out of the
machine.
The brew unit is not in the correct
position. This can happen if, for
example, the machine door is opened
during grinding or brewing.
^ Close the door. The brew unit will
position itself correctly automatically.
. . . the crema is not as it should be.
^ Check that the grinder setting is not
too coarse or too fine, and adjust
accordingly (see "Setting the coffee
grinder").
^ Check the temperatures the different
types of coffee have been set to. If
the temperature is too high, there will
be dark patches in the crema.
Reduce the temperature (see
"Settings: customising your machine -
Setting the temperature").
The crema will not form correctly if stale
coffee or an unsuitable coffee blend is
used or if the central spout is set too
high.
Problem solving guide
. . . the central spout connector cap
is faulty (see "Guide to the machine -
interior view").
^ Replace the cap with the spare part
supplied.
^ Lubricate the cap of the central spout
connector with the silicone grease
supplied.
. . . the message "Push water
container in as far as it will go"
appears in the display.
Water has not been taken in.
^ The water container has not been
correctly positioned inside the
machine. Take it out and push it back
into the machine so that it clicks into
position.
^ This fault message also appears if
the water container was not correctly
filled for descaling. Fill the water
container up to the marker.
If this fault message still continues to
appear in the display, repeat the steps
described above. If neither is the case
and the fault message still appears in
the display, call the Miele Service
Department.
71