Miele CVA 5065 Operating And Installation Manual page 70

Problem solving guide
. . . water or milk stops flowing whilst
programming in the amount to
dispense.
The flow stops automatically when the
maximum fill quantity is reached. The
maximum quantity is stored in memory.
If there was not enough water or milk in
the water container or milk flask, the
amount that has been dispensed will
not be saved to memory.
^ Fill the water container or the milk
flask, and repeat the process to
programme in the amount.
. . . there is water in the waste
container.
This is not a fault. The water is left over
from the brewing and cleaning process.
. . . there is a lot of residual "coffee
water" in the waste container.
If the slide control for the grinder is set
to too coarse a setting, too much
residual "coffee water" can be left in the
waste container.
^ Set the grinder on a slightly finer
setting (see "Setting the coffee
grinder").
^ If necessary, adjust the amount of
coffee (see "Settings: customising
your machine - Setting the amount of
coffee").
Is the central spout connector cap
positioned correctly?
^ Lubricate the cap of the central spout
connector with the silicone grease
supplied.
70
^ If the cap is faulty, replace it with the
spare part supplied.
. . . the descaling programme was
started by mistake.
The descaling programme cannot be
cancelled once you have touched the
OK sensor. The programme has to be
carried through to the end. This is a
safety measure to ensure that the
machine is fully descaled, and is
important for the long-term protection of
the machine and to ensure it functions
correctly.
^ Descale the machine (see "Descaling
the machine").
. . . the coffee machine makes loud
noises during the descaling
programme.
During the descaling programme you
will hear loud noises as water is flushed
through the machine under high
pressure. These are no cause for
concern.
. . . the heating-up time is getting
longer, the amount of water coming
through is incorrect and the machine
is not performing properly.
The machine needs descaling.
^ Descale the machine (see "Descaling
the machine").