Miele CVA 5065 Operating And Installation Manual page 72

Problem solving guide
. . . the message "Check water inlet"
appears in the display.
There is a problem with the water inlet
for the plumbed in water supply.
^ Check whether the inlet hose has
become kinked or the stopcock is not
fully open.
^ Remove the water container and
empty it.
^ Push the water container into the
appliance so that it clicks into
position.
If the fault message appears in the
display again, contact the Miele Service
Department.
. . . too much crema has formed and
is overflowing above the central
spout.
Some types of coffee will produce too
much crema if the coffee or espresso
temperature is set to maximum and the
amount of coffee to be ground is set too
high.
^ Set a lower temperature and reduce
the amount of coffee to be ground
(see: "Settings: customising your
machine - Setting the temperature
and Setting the amount of coffee).
. . . the slide control for the grinder
setting will not move.
^ Close the machine door and
dispense a cup of espresso coffee.
The grinder setting slide control will
now move.
72
. . . "Fault - 1" to "Fault - 4" or "Fault -
80" to "Fault - 83" appears in the
display.
^ Switch off the machine using the
On/Off sensor and wait for one hour
before switching it on again.
If the fault message appears in the
display again, contact the Miele Service
Department.
. . . the message "Fault - 28" appears
in the display.
The chute will only take enough ground
coffee for one portion, i.e. a level
coffeespoonful of ground coffee. If
there is too much ground coffee, the
machine is unable to process it so that
it can be emptied into the waste
container, and a fault message appears
in the display.
^ Switch the machine off and then back
on again.