Mouse Control - ADDER View 4 Installation And Use Manual

'HOTKEYs' and 'TAB' - selects the next active channel if the ADDERview has been
set to scan active ports (see section 2.5, option switch 2). Selects the next
numbered channel in sequence if the ADDERview is set to scan all ports.
'HOTKEYs' and 'A' - selects auto-scan mode where each channel is displayed in
turn for a selected time. The ADDERview can be set to scan all ports or just the
active ports. The video from each CPU is displayed for 2 or 5 seconds according to
the option switch settings (see section 2.5). To cancel auto-scan mode simply select
any fixed channel either by using the hotkeys or the ADDERview's button.
'HOTKEYs' and '0' - Disables the ADDERview's shared video and switches all the
channel lights off. The video can be re-enabled by selecting a channel.
Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):
To select channel 2:
ba 2 ba
press
To 'tab through' channels:
ba v ba
press
release

3.5 Mouse control

The channels can conveniently be changed on ADDERview by using a three button
mouse. In order to switch to the next channel simply hold down the central mouse
button (the wheel mouse button on an IntelliMouse) and click on the left hand mouse
button. The channel will then change. If the ADDERview has been set to scan active
ports then the next active channel will be selected. If it has been set to scan all ports
then the next numerical channel in sequence will be selected
ADDERview
2
release
v
release
v v v v
press
Installation and Use
2 ba ba
2
v v v v
press
vba vba
release
Page 16