Keyboard Hotkey Control - ADDER View 4 Installation And Use Manual

3.4 Keyboard hotkey control

ADDERview can be conveniently controlled by selecting a channel, or auto-scan
mode from the keyboard. All of the hotkey control commands are invoked by holding
down the two hotkeys and then pressing a command key. By default, the two
hotkeys are 'CTRL' and 'ALT', although other combinations can be selected using
the option switches. Once the hotkey command has been activated you will need to
release the hotkeys and the command key before a new hotkey command is
accepted by the ADDERview. HOTKEYs + TAB is an exception and this allows you
to 'tab through' the ports by holding down the hotkeys and repeatedly pressing TAB.
The hotkey command are summarised below (note that the numbers on the numeric
keypad do not form part of a valid hotkey) :
'HOTKEYs' and '1' - selects channel 1
'HOTKEYs' and '2' - selects channel 2
'HOTKEYs' and '3' - selects channel 3
'HOTKEYs' and '4' - selects channel 4
ADDERview Installation and Use Page 15