ADDER View 4 Installation And Use Manual page 25

Problem:
Mouse causes channel to change.
Action:
Some cheaper mice are not fully compatible with the ADDERview and can lose data
causing the channel to be changed (if mouse switching of channels is enabled). If
you experience this problem then change the mouse and use a Microsoft, Logitech,
IBM, Compaq or Hewlett-Packard type. Ensure that you are using a Microsoft
compatible mouse driver on your PC. Some other manufacturers' drivers may switch
the mouse to use a proprietary mouse data format not supported by the
ADDERview. If you have unplugged and re-connected a mouse to the ADDERview
then ensure that you reset it using the mouse reset function (see sections 2.7, 3.7 ).
Problem:
Mouse jumps around the screen after disconnecting the mouse cable or powering
down the ADDERview.
Action:
If you have disconnected and re-connected a CPU mouse cable or you have reset
the ADDERview then the mouse data format may be out of synchronisation with that
required by the PC (PS/2 or Intellimouse). Try the mouse restoration functions or re-
power the CPU.
ADDERview Installation and Use Page 24