Table of Contents
Advertisement
AdderView MP can be re-enabled by selecting a channel. If a password has been
set then the AdderView MP displays 'P' to indicate that a valid password must be
entered to unlock the switch. Simply type the same key combination as was set
during configuration (see section 4.7) followed by the (return) key. Note - if anyone
has typed at the keyboard whilst in secure mode, it will be necessary to type (return)
first to clear the invalid password, then type the valid password followed by (return)
again.
Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):
To select channel 2:
ba2
ba2
press
To 'tab through' channels:
ba
ba v
press
release
3.5 Mouse control
Computers may conveniently be selected using a three button mouse. In order to
switch to the next computer simply hold down the central mouse button (the wheel
mouse button on an IntelliMouse) and click on the left hand mouse button to select
the next computer or the right hand mouse button to select the previous computer. If
the AdderView has been set to scan active ports then the next or previous active
channel will be selected. If it has been set to scan all ports then the next or previous
numerical channel in sequence will be selected (see section 4.5 for more details).
Mouse switching may be enabled or disabled by setting options during configuration
(see section 4.3). When mouse switching is disabled the third button or wheel button
state is 'passed through' the AdderView and seen by the application software.
AdderView MP
release
v
release
v
v
v
v
press
Installation and Use
2ba
2ba
v
v
v
v
press
vba
vba
release
Page 30
Advertisement
Table of Contents
