Microcom 470 Operator's Manual page 55

Chapter 5
))))))))))))))))))))))))))))))))))))))))))))
^A ^D Command
24 Change SW4: Change software dip switch #4. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.)
******.))
*****.)))
****.))))
***.)))))
**.))))))
*.)))))))
.))))))))
Position:
1 4" Epson® Similar Emulation: When set, the printer operates similar to an
Epson® printer with an 80 column format. This parameter enables the emulation
on printer power-up (Also see the ^A1^D38 command in section 5.3).
2 2" Epson® Similar Emulation: Same as position 2, but prints in a 40 column
format. (Also see the ^A2^D38 command in section 5.3.)
3 Blow-hole Stock: Enable this position when using blow-hole or cut-slot stock:
Stock that uses a hole instead of a gap to separate labels.
4 Auto-size on power-up: When enabled, the printer automatically sizes the label
stock when turned on. The printer then uses these header values for all
subsequent label formats. See the ^D39 command in section 5.3 for more
information on auto-sizing.
5 Pass ASCII Text Over 7F: If set to 1, the printer will process characters over 7F
hex.
6 European Configuration
7 European Configuration
8 European Configuration
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual
Not Used
Not Used
Not Used
1=Pass ASCII over 7F, 0=Less than 80 only
1=Auto-size on Power-up Enable, 0=Disable
1=Blow-hole Stock Enable, 0=Disable
1=2" Epson® Emulation Enable, 0=Disable
1=4" Epson® Emulation Enable, 0=Disable
Printer Commands
47