Raid Status Information - Intergraph InterServe 800 SL System Setup

What do you want to do?
View the power supply
status
View the voltage status -
550 Watt power supplies
only
View the system power
status
View power distribution
board information
View LCD board
information
Set the system monitor
firmware password
Change the polling interval
Change the ambient heat
threshold
View the state of the
system monitor firmware
when last rebooted
Manually reboot the system
monitor firmware

RAID Status Information

The following table provides a view of how to use the configurable options and view status
information for the RAID disk section. This information is not available for non-RAID
systems.
What do you want to do?
Turn off the RAID alarm
View RAID configuration
information
View the last POST results
View the internal
temperature
View SCSI ID information
View the internal heat
threshold
Follow this menu path
System Status > Power Supply
System Status > Voltages
System Status > Sys. Power
System Config. > Power Plane
System Config. > LCD Display Panel
Utility > Set Password
Utility > System Status Poll
Utility > Heat Threshold
Utility > Last Reboot Boot State
Utility > Firmware Reboot
Follow this menu path
TURN OFF ALARM
HARDWARE MENU > CONFIGURATION INFO
HARDWARE MENU > POST RESULTS
HARDWARE MENU > INTERNAL TEMP
OPTIONS MENU > SCSI ID MENU
OPTIONS MENU > HEAT THRESHOLD
49
See page
53
55
55
55
56
56
56
57
58
58
See page
59
60
60
60
60
61