System Self Diagnostic Test - Teledyne 3010PA Operating Instructions Manual

Oxygen Analyzers
1. Disconnect the Unit from its power source.
2. Place a small screwdriver in the notch in the fuse holder cap,
push in, and rotate 1/4 turn. The cap will pop out a few milli-
meters. Pull out the fuse holder cap and fuse, as shown in
Figure 5-3.
Figure 5-3: Removing Fuse Cap and fuse from Holder
2. Replace fuse by reversing process in step 1.
5.4
1. Press the System button to enter the system mode.
2. Use the < > arrow keys to move to More, and press Enter .
3. Use the < > arrow keys to move to Self-Test, and press Enter .
4. Observe the error-code readings on the VFD Display screen,
and check Table 5-1, below, to interpret the codes.

System Self Diagnostic Test

Part II: Analysis Units
Part II: 5-7