Autotest Results For Twisted Pair Cable - Fluke DSP-100 User Manual

DSP-100/2000
Users Manual

Autotest Results for Twisted Pair Cable

To see detailed results from a test, use
Autotest menu; then press
The tests run during an Autotest on twisted pair cable depend on the
test standard selected. Tests not applicable to the selected test
standard are not run or displayed. For a list of tests applicable to
various test standards, see Table C-1 in Appendix C.
Wire Map Test
The wire map test tests and displays the wire connections between the near and far
ends of the cable on all four pairs. Shield continuity is also tested if a shielded
cable type is selected and you have not disabled shield testing in SETUP. The
pairs tested are those defined by the selected test standard. Table 3-1 shows
examples of wire map displays.
If the wire map test passes, the Autotest continues. You can view the wire map
test results when the Autotest is complete. If the wire map test fails, the Autotest
halts and the wire map screen appears with the word
the wire map results by pressing
Wire Map
Condition
Correct wiring
(Top row
represents near-
end connector.)
3-6
.
Note
. To continue the Autotest, press
.
Table 3-1. Wire Map Displays
Display
gc42i.eps
to highlight the test on the main
. You can then save
Schematic
(only affected pairs
shown)
1 1
2 2
3 3
6 6
4 4
5 5
7 7
8 8
gc43i.eps
Description
Cable wiring is
correct. Shield ( )
shown only if
required by
selected test
standard.