Fluke DSP-100 User Manual page 140

DSP-100/2000
Users Manual
If you are storing the test tool or the smart remote for an extended period of time,
charge the NiCad battery pack before storing. Do not remove the battery pack.
Removing the battery pack for extended periods shortens the life of the backup
lithium battery.
Before storing the standard remote for an extended period of time, remove the
alkaline battery to prevent damage from battery leakage. Figure 8-1 shows how to
remove the remote battery.
Replacing the NiCad Battery Pack
Replace the NiCad battery pack when its life between full charges becomes
noticeably shorter. The battery is normally good for up to 1,000 charge/discharge
cycles. Figure 8-2 shows how to remove the battery pack.
This instrument contains a Nickel-Cadmium battery. Used batteries
should be disposed of by a qualified recycler or hazardous materials
handler. Contact your authorized Fluke Service Center for recycling
information.
8-2
Figure 8-1. Removing the Battery in the Standard Remote
N
Note
gc38f.eps