Fluke DSP-100 User Manual page 37

Selecting a Language for Displays and Reports
The test tool displays results and prints reports in English, German, French,
Spanish, and Italian.
To select a language for displays and reports, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
3. Use to highlight the currently selected language.
4. Press
5. Use
6. Press
appears in the selected language.
Performing a Self-Test
The self-test verifies that the test tool and the remote are operating properly. To
run the self-test, proceed as follows:
1. Turn the rotary switch to SPECIAL FUNCTIONS.
2. Use to highlight
3. Press
4. Use the 2m Cat5 patch cable provided to connect the test tool to the remote as
described on the display.
5. Press
6. When the self-test is complete, you can either return to the main Special
Functions menu by pressing
rotary switch to a new position.
If the self-test fails, refer to "If the Test Tool Fails" in Chapter 8.
four times.
.
to highlight the language you want.
to accept the highlighted language. The test tool's display now
.
to start the self-test.
Turning On the Test Tool
.
or start a new operation by turning the
Getting Started
2
2-21