Quick Configuration - Fluke DSP-100 User Manual

DSP-100/2000
Users Manual

Quick Configuration

The settings listed in Table 2-3 affect either the display format or the accuracy of
your test results. Following the table are instructions for changing the settings. For
a complete list of the test tool's adjustable settings, refer to the later section
"Setup."
SETUP Setting
Test Standard and
Cable Type
Average Cable
Temperature
Conduit Setting
Remote End
Testing
Length Units
Numeric Format
Display and Report
Language
Power Line Noise
Filter Frequency
2-4
Table 2-3. Quick Configuration Settings
Select the test standard and cable type you are using. Your selection
determines which test specifications are used and which tests are run during
cable testing. Fiber optic cable testing requires a Fluke DSP Fiber Optic
Meter.
Select the cable temperature range that includes the average temperature
where the cable is installed. Cable temperature is not applicable to all test
standards.
The conduit setting is not applicable to all test standards.
Enables execution of the REMOTE tests. Select Disable or Auto Detect when
using a standard remote.
Select meters or feet as the unit for length measurements.
Select a format (0.00 or 0,00) for display of decimal fractions.
Select English, German, French, Spanish, or Italian.
Select the frequency of the ac power in your area. The test tool filters out 50
or 60 Hz noise from measurements.
Description