Auditing Accounts - Sharp SF-2530 Operation Manual

AUDITING ACCOUNTS

If this copier has been programmed in the auditing mode, it will not
function until an assigned 3-digit account number has been entered.
See page 37 for setting the auditing mode.
1 2
4 5
7 8
LECT
0 C
CLEAR ALL
8
If the copier has been programmed in the auditing mode, "––" will
appear in the copy quantity display in the initial conditions.
1 Enter your account number using the 10-key pad.
3
As each digit is entered, the dashes in the copy quantity display
will disappear.
6
After the number is entered, the copy quantity display will
change to 0 and the START key indicator will light up.
9
If an unassigned number is entered, "––" will appear again in the
copy quantity display, indicating that the number was not
accepted.
When a copy run is completed, press the
2
"––" will appear again in the copy quantity display, indicating the
auditing mode.
In the interrupt copy mode (see page 19), press the INTERRUPT
key after an interrupt copy run is completed.
key.