Interrupting A Copy Run - Sharp SF-2530 Operation Manual

INTERRUPTING A COPY RUN

INTERRUPT can be used to temporarily stop a long copy run so that
another job can be run.
Reduction/enlargement/zoom, exposure adjustments, dual page
copying, edge erase, and margin shift can be selected during
interrupt copying.
Duplex copying, sort, group, and staple sort cannot be selected
during interrupt copying.
INTERRUPT will not function during duplex copying or when an
optional auditor (SF-EA12) is used and the copier has been
programmed in the auditing mode.
INTERRUPT
CLEAR ALL
START
9
INTERRUPT
CLEAR ALL
Press the INTERRUPT key.
1
The copier will return to the initial settings.
If this copier has been programmed in the auditing mode using
auditing program No.10, "– – " will appear in the copy quantity
display. Enter your account number using the 10-key pad. The
number of copies of the interrupt copying will be accumulated
against this account number. See page 8.
When an optional document feeder (ADF or RADF) is being
used, the copier will stop after completing the copying of the
originals which have been fed into the document feeder.
When the copier stops, remove the original(s) and place
2
the original for interrupt copying on the document
glass. Close the document cover.
If an optional document feeder (ADF or RADF) is installed, place
the originals face up in the document feeder tray.
Select the desired available copier functions.
3
Press the START key.
4
When the interrupt copy run is complete, press the
5
INTERRUPT key again to cancel the mode and remove
the original(s) used for interrupt copying.
The copier will reset itself to the functions which were in use
before the INTERRUPT key was first pressed.
6 Replace the original(s) for the interrupted job and press
the START key to resume copying.
19