Siemens SICLOCK TC 400 Operating Instructions Manual page 93

Table 10-1 List of the parameters of SICLOCK TC 400
1)
Access Parameter
/ No.
Network Settings/Ethernet 4
IP Adapter 4
0.05.04
Network Adapter 4
0.05.08
Line State Adapter 4
0.09.16
Advanced Settings
Adapter 4
0.05.12
SIMATIC Method
Ethernet 1
0.15.01
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400
Entry
IP address
subnet mask
gateway
hardware address
link
linespeed
duplex
monitor link state
mode
send condition
destination address
Parameter Table
Value Range / Default
Min: 0.0.0.0
Max: 255.255.255.255
Default: 192.168.4.40
Min: 0.0.0.0
Max: 255.255.255.255
Default: 255.255.255.0
Min: 0.0.0.0
Max: 255.255.255.255
Default: 0.0.0.0
Min: 00.00.00.00.00.00
Max: FF.FF.FF.FF.FF.FF
Default: 00.00.00.00.00.00
Min: ---
Max: down
Default: ---
Min: ---
Max: 100 Mb/s
Default: ---
Min: ---
Max: half duplex
Default: ---
Min: off
Max: alarm
Default: off
Min: off
Max: S5-compat., every 10 s
Default: off
Min: ---
Max: only if synchronized
Default: ---
Min: 00.00.00.00.00.00
Max: FF.FF.FF.FF.FF.FF
Default: FF.FF.FF.FF.FF.FF
10-91