Dimension Drawing; Mounting Position And Fixing Method; Installation Instructions - Siemens SICLOCK TC 400 Operating Instructions Manual

4.4

Mounting position and fixing method

4.4.1

Installation instructions

Before installing the device, read the following general installation instructions.
Warning
Hazardous voltage
Isolate the power supply to the control cabinet before opening it. Ensure that the
power to the control cabinet cannot be turned on accidentally.
• Position the device/display in an ergonomic position favorable to the user.
Choose a suitable installation height.
• Position the device/display so that it is not subject to direct sunlight or other
strong sources of light.
• Provide adequate volume in the control cabinet for air circulation and heat
transport. Maintain a clearance of 100 mm above and below. This clearance
is increased accordingly with connection cables.
• Position the device so that the air vents of the housing are not covered up fol-
lowing installation.
• Also provide enough free space for device expansions.
• Note the reinforcement in the control cabinet for stabilizing the installation cut-
out. Install reinforcement if required.
• Install the device in such a way that there is no danger, for example, of it falling
out.
• During assembly, please comply with the permissible mounting positions.
See also Dimension Drawing (Section 14).
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400
Operation Planning
4-29